1-1/4 teaspoon citric acid
1 gallon milk(whole milk for a richer flavor or skimmed milk for low calorie cheese)
2. Dissolve 1-1/4 tsp. citric acid powder in 1/2 cup cool water. Add to 88ºF milk, stir well.
3. Dissolve 1/2 tablet Junket Rennet into 1/4 cup cool water. Stir thoroughly into warmed milk mixture. Let set undisturbed for 1-2 hours, until a clean break is achieved.
4. Cut curd into 1/2 inch cubes.
5. Warm the curds and whey over low heat, stirring gently to warm evenly and keep the curds separated until temperature reaches 42º C (108ºF). Hold at 42ºC for 35 minutes, stirring every five minutes to keep curds separated and off the bottom.
6. Collect curds by pouring curds and whey through a fine cloth held in an 8 inch sieve over a 1 gallon container, let drain for 15 minutes. Save whey to make ricotta if you wish (see recipe)
7. Break up curd, mix in 1 teaspoon salt thoroughly.
8. Place 1 cup of salted curd into 2 cup measure.
9. Microwave on high for 45 seconds
10. Separate hot curd from container with the back of a fork, knead with hands to distribute heat evenly. Heat again for 20 more seconds. Stretch and fold to make smooth and elastic, shape into a soft ball.
11. Drop into cold, salted water (1/3 cup salt per quart), let sit in refridgerator for a day, store in an air tight container. Use within a week or so.
1/2 cup water
1 gallon skim milk
1/4 cup buttermilk
1 teaspoon salt
1/3 cup cream
1. Dissolve Rennet Tablet in water by crushing. Set aside. In a large saucepan, heat skim milk to 70º F. Stir in buttermilk and Rennet Tablet solution, mixing well. Cover with towel and let stand at room temperature 12 to 18 hours until firm curd forms. To test for a firm curd, remove a milk sample at a point near the edge of the saucepan with a spoon. The curd is ready to cut when the coagulated milk sample holds its shape and the edges are sharply defined.
2. Cut curd into 1/2-inch long pieces using a long knife. Heat curd slowly over hot water until temperature reaches 110ºF. Hold curd at that temperature for 20 to 30 minutes, stirring at 5-minute intervals to heat curd uniformly. Pour mixture onto the fine cheesecloth in a colander and drain off whey.
3. After whey has drained 2 to 3 minutes, lift curd in cheesecloth and immerse in pan of cold water 1 to 2 minutes, stirring and pressing with a spoon. Then immerse in ice water 1 to 2 minutes. Drain the curd until it is free from whey and place in a large bowl. Add salt and cream and mix thoroughly. Chill.
Please note: The use of any type of Lactaid milk with Junket Rennet Tablets will cause the custard to not set.
1/4 cup active cultured buttermilk (1/2 cup plain yogurt will also work yogurt must contain live and active culture)
1/2 tablet rennet (1/4 tablet will work, but takes a bit longer to coagulate, see step 5)
thermometer, reading range 0 to 225F (-10 to 110C)
whisk or other effective stirring and mixing device
Sterilized2 stainless steel 4-6 quart pot1 with lid. (A thick metal bottom prevents burning.)
Long bladed knife (9-10 inches long)
large handkerchief, sterilized by boiling and drying
cheese pressing frame (4" diameter, 5" tall can, about 20 oz, ends removed, save one end for a follower)
1. INOCULATE THE MILK: The evening before you plan to make cheese, warm 1 gallon of fresh milk to 68F (20C) in the sterilized pot. Thoroughly blend in 1/4 cup buttermilk to inoculate. Cover inoculated milk with the sterilized lid.
2. INCUBATE OVER NIGHT: Let sit out at room temperature overnight.
3. WARM THE MILK: The next morning, gently warm the milk up to 86F (30C). Meanwhile, dissolve 1/2 tablet of Rennet in 1/4 cup cold water.
4. ADD THE RENNET: Stir the dissolved rennet into the 86F milk to mix thoroughly. Cover, let sit undisturbed for an hour or more in a warm place in the room. Be patient. Do not disturb the milk until it has coagulated.
5. ACHIEVE A CLEAN BREAK: Test for a "clean break" (completed action of rennet): Probe a clean finger into the milk and lift. If it has gelled enough to break cleanly as the finger is lifted, go to next step. If the milk is liquid or semi-gelatinous and softly flows across your finger, let sit until a clean break is obtained. It may take as long as 1-2 hours more. Be patient, do NOT disturb the milk.
6.CUT THE CURD: Once a clean break is achieved, cut the curd with a long knife: begin at one edge of the pot and cut straight to bottom. Cut repeatedly parallel to first cut, but increasing the angle of the knife until reaching 45 degrees at the other side of pot. Rotate the pot a quarter of a turn, cut as before. Repeat the rotating and cutting two more times, yielding 1/2 inch cubes of curd.
7. SET THE CURD: Place the pot over a low fire, stir curd with cleaned bare hand by reaching down to bottom, gently lifting and stirring. Cut larger curds as they appear. Do not mash or squeeze. Continue stirring for 15 min to prevent the curds from clumping together or overheating at the bottom. Warm the curds to 92F (34C) for softer curd cheese, or as high as 102F (39C) for very firm cheese.
8. SEPARATE CURDS AND WHEY: Stir and maintain 92F until curd has contracted to consistency of firm scrambled eggs. Remove from stove and let sit for 10 minutes. The curds should sink in whey. Pour off the whey through a strainer and save for ricotta if you wish. Place the curds in a large bowl.
9. ADD SALT: Sprinkle two teaspoons salt over curds, working with hands to mix in. Pour off any additional whey.
10. PRESS THE CHEESE: Line a smooth-sided 4" x 5" tin can from which both ends have been removed with a sterile large white handkerchief. Place the still-warm curds into the cloth, press into the can. Fold the corners of the cloth over top of the curds and cover with the cut-out end of the can. Place a heavy weight on top to press down the curds. Let sit at room temperature for 12 hours or so.
11. CURE THE CHEESE: The next morning, remove and unwrap the cheese from the press. Rub the outside with salt, re-wrap with a fresh handkerchief and place on a rack in the refrigerator. Replace "bandage" when it becomes wet (daily at first). When a dry yellowish rind forms (about one to two weeks in the refrigerator), dip in melted wax, store in refrigerator for about a month (if you can wait that long). The longer you wait, the sharper the cheese.
Sterilize the pot just before use by pouring 1/2 inch of water in the bottom, covering, and bring to a rolling boil for at least five minutes. Pour out the water, replace sterile lid, keep sterilized pot covered until you are ready to add the milk.
2) thermometer should read in the range of 32-220 F (0-110 C)
3) long bladed knife to cut the curd
4) quart strainer to support the draining cloth (handkerchief)
5) 2 sterile handkerchiefs draining cloth, sterilized by boiling and hanging to dry
6) receiving container to catch draining whey. A one gallon bowl or clean plastic bucket will do.
7) cheese mold and weight Cut the ends out of a smooth-sided 4 x 5 inch tin can, save one of the cut ends for the press
1 gallon milk whole milk for a richer flavor or skimmed milk for low calorie cheese
1 Tbl fresh active plain yogurt to use as an inoculum (yogurt must contain live and active cultures)
1/2 tablet Junket Rennet to coagulate the milk
5 Tbl table salt to prepare the pickling brine
2. Mix yogurt with an equal part milk to blend, then stir into the warmed milk to mix thoroughly.
3. Cover and let inoculated milk sit for one hour at room temperature. Meanwhile, dissolve 1/2 Junket Rennet tablet in 1/4 cup of cool water.
4. After the inoculated milk has set for one hour, stir in the dissolved rennet to mix well.
5. Cover and let the inoculated, renneted milk sit overnight at room temperature.
6. The next morning, the milk should have gelled to produce a clean break (as in the basic cheese recipe). Some of the whey will have separated. Cut curd as per basic cheese (see recipe). The curds should be about 1/2 inch in diameter.
7. With very clean hand and arm, reach to the bottom of the pot and gently lift the curds to stir. Cut large pieces which appear with a table knife so that they are 1/2 inch pieces. Continue gentle stirring for 10-15 minutes until curd is somewhat contracted.
8. Decant off the whey through the handkerchief supported by the strainer, then pour curds into handkerchief. Let the curds drain until no more whey drains out (about 2-4 hours). The whey may be saved for ricotta (see recipe).
9. Transfer the drained curds into a bowl, break into small pieces and mix in 1/2 tsp salt.
10. Prepare the cheese mold by lining the tin can (with ends cut out) with a handkerchief. Place the curds into mold, fold over ends of the cloth, place one of the cut ends on top, and place a heavy weight on top to press the curds. Let sit overnight to drain.
11. Prepare pickling brine (12.5% salt): 20 oz of water plus 5 Tbl salt. Stir to dissolve.
12. Remove the cheese from the press and cut into 1.5 inch pieces. Place into a wide-mouth quart jar. Pour brine over to cover. Let pickle for 1-2 days in the refrigerator. The cheese pieces may then be removed from the brine and stored in an air tight container in the refrigerator. Rinse before use to remove excess salt.
whisk, used to mix ingredients. Try not to create foam.
thermometer, should read in the range of 32-220 F (0-110 C)
sterile handkerchief, sterilized by boiling and hanging to dry
receiving container, to catch draining whey. A one gallon bowl or clean plastic bucket will do.
1/4 cup culture buttermilk (fresh)
1/4th tablet Junket Rennet tablet
This is a soft, spreadable cheese originated in France and is eaten fresh. Sometimes called "farmer's" cheese, think if it as a low fat cream cheese which can eaten on crackers straight or mixed with seasonings, used in cheese cake, folded into omelets, etc.
2. Meanwhile, dissolve 1/4 tablet rennet in 1/4 cup water.
3. When the milk reaches 65 F, remove from heat, add buttermilk, whisk to mix thoroughly.
4. Stir the dissolved rennet into the 65 F inoculated milk, blend thoroughly.
5. Cover and let sit overnight undisturbed at room temperature (65-70F, 20C).
6. The next morning, a clean break should have formed (see recipe for basic cheese for the test). If the coagulated milk is not firm enough, let it sit until is does, as long as another 12 hours.
7. When a clean break is achieved, cut the curd into 1/2 inch cubes (see recipe for basic cheese for technique). Some recipes call for stirring the soft curd with a whisk. This will work, but will make the separation of curds and whey more difficult.
8. Ladle the curds and whey into a clean sterile handkerchief supported in a large strainer, placed over a one gallon bowl. Allow the whey to drain through. If the cloth becomes clogged, lift the cloth back and forth or scrape the curd away from the cloth. Save the whey for ricotta if you wish (see recipe).
9. When most of the whey has drained through, pick up the four corners of the cloth and suspend the curd in a cool place to drain overnight (from a shelf of the refrigerator if you have room).
10. The next day, remove the cheese and mix in1- 3 teaspoons of salt, according to taste. It may be eaten immediately. Store covered in the refrigerator until use.
11. You may pack the cheese into a mold of your choice (a squat tin can with the ends removed for instance).
1 c. buttermilk
2 rennet tablets dissolved in 1 T. cold water
2 c. dry milk powder
2 T. vegetable oil (opt.)
Blend all ingredients and place in a heavy saucepan coated with a nonstick spray. Let sit undisturbed for 10 minutes. Cut or stir to break into curds and cook over medium heat for five minutes. Pour curds into a strainer, rinse with hot, then cold water, and drain. Salt to taste, then refrigerate. Or, place in a cheesecloth bag and press. This is a very mild cheese, good with salt and chopped chives. Use within 3-4 days. To make cream cheese from this recipe, reduce rennet to 1/4 tablet and add 1 c. buttermilk when mixing ingredients. Set in a warm place overnight. After cutting set curds into cubes, place curds over medium heat, and cook five minutes. Pour into a cheesecloth lined colander and let rest 15 minutes. Gather edges of bag, secure with a rubber band and hang, or press until firm like cream cheese. Add salt if desired.